Frequently Asked Questions - Contact Us

All control cords are normally 1/2 the length of the blind when manufactured. If you feel your control cords are too long, you can follow these steps to shorten.

1. Fully lower the blind, and then push the control cords through the tassel to expose the knot.
2. Move tassel up the cords to the desired end position, and then tie a new knot below the tassel. Make sure the knot is large enough to hold the tassel in place and prevent cords from slipping through.

Test new tassel location and cord length by raising and lowering the blind. If you are satisfied with new knot position, cut off the excess cord below the new knot.